Screen Washout Booths

Short Description:

Washout booth is essential for maintaining an efficient screen printing preparation and reclaiming room. The proper disposal of ink, chemicals, and emulsion by-products is critical. Waste solids have the potential to ruin plumbing and septic systems and have harmful effects on the environment.

The screen stencil wash out machine is used for washing stencils before exposure processing or developing stencils after exposure processing, also it is used for cleaning the inks on stencilsafter printing.

  • Model Number: JM-WT-2
  • Tank size: 31*24*31in
  • Voltage: 220v/110v
  • Power: 48w
  • Plug: American standard,National standard,European standard
  • Machine using material: steel plate
  • Product Detail

    Product Tags

    JM-WT-2 Stand Type Washout Tank With LED Light


    This machine is special equipment that clean the screen printing frame


    The function and features of this machine:

    1.Rinse tank long 60 cm ; Width 80 cm, tall 80 cm; screen frame fit size is length 80 cm to 80 cm length 
    2.The back of rinse area install 54*54cm LED flat light(power48W);Can be directly observed during flushing screen mesh;
    3.LED lights isolation plate install 4 mm acrylic transparent board; The waterproof board resistant to cleaning, abrasion resistance, anti-aging, long-term use without deformation, no damage.



    At the front set have curtain, to prevent when the spray splash to the operator.
    5.There are three height adjustment holes on both sides of the curtain, So that the curtain can be adjusted up and down 14 cm;according to the height of operator and adjust it.
    6.There are rack in the tank it can be according to screen dimension and rinse screen frame angle in any different positions.
    7.The edge of baffle have water hole,so the water flow into the sewer in time.
    8.With s-shaped odor-proof sewer,the length of it is 300cm.
    9.Put four heights or width of 55cm frame in rack at the same time,when you couldn’t use the rack and push to the side.


    10.The lower part of the water control rack is equipped with a water tray, and the remaining water on the screen is collected and cleaned up together.
    11.The bottom of water control rack install clapboard,could place tools and materials.
    12.The bottom of machine install wheels,move it at will.
    13.The machine adopts electrostatic spraying,corrosion resistance,resistant to cleaning,no rust.
    14.The machine adopts modular structure;equipped with full set tools and instruction.


    When install this machine,the connecting screws in the box with waterproof aprons,the apron is installed inside the box to prevent to leakage.

    Product Code

    JM-WT-2A(110V) JM-WT-2B (220V)

    Product Name

     Stand Type Washout Tank with LED light

    HS code


    Product Color


    Tank size







    American standard,National standard,European standard

    Machine using material

    steel plate

    Machine surface treatment

    Electrostatic spraying

    Attachment material

    Stainless steel or zinc plating, nickel plating

    Machine size


    Net weight


    Gross weight


    Packing size


    Packing volume

    0.34 m3

    Packing material

    Export fumigation-free wooden case


  • Previous:
  • Next:

  • Write your message here and send it to us